Central Air Installation
For homes without existing ductwork, this covers adding a full central cooling system.
The difference between replacing a unit and installing a system
Swapping an old condenser for a new one of the same size is fast, and it is also the most common way homeowners end up with a system that never feels quite right. The original unit may have been oversized from the day it went in. The house may have gained insulation, new windows or an addition since then. Copying the old tonnage copies whatever mistakes were already there.
An oversized air conditioner cools the air near the thermostat quickly and shuts off before it has run long enough to pull moisture out of the house. Rooms feel cool but damp, and the short, frequent cycles wear components faster. An undersized unit has the opposite problem: it runs constantly on hot afternoons and still falls behind. The right size keeps cycles long enough to dehumidify while still meeting the hottest days your home actually sees.
Sizing comes from the ACCA Manual J procedure, applied to every room rather than the house as a whole. We record room dimensions, glass area and which way it faces, insulation depth, air leakage, ceiling height, where the ducts run and the size of your household. The result is a heating and cooling load for each room, which also shows where airflow needs to go.
Equipment selection comes next. The outdoor condenser and indoor coil must be a matched pair, meaning the combination has been tested and rated together, so the efficiency and capacity on paper are the numbers you actually get. We review whether your existing furnace or air handler can deliver the airflow the new coil needs. If it cannot, the proposal says so and explains why, rather than leaving you to discover weak performance later.
Refrigerant is part of the conversation too. Under federal EPA rules, new residential air conditioning equipment has been moving to lower global warming potential refrigerants such as R-454B and R-32. These are classified as mildly flammable, and they come with specific installation requirements that our technicians follow. Whether an existing line set can be reused depends on its size, condition and the manufacturer instructions for the new equipment, and we check all three.
On installation day, line sets are brazed with nitrogen flowing through them to prevent internal scale, pressure tested to confirm there are no leaks and evacuated with a vacuum pump to remove moisture before refrigerant is released. The charge is set by weight and then verified with superheat or subcooling readings. If your system will also need attention on the airflow side, our Ductwork Install And Replace page explains how we evaluate and correct duct problems.
We are family owned and have been installing cooling systems in Cypress Landing, NC since 2008. Every installation is permitted where required, covered by a written workmanship warranty and registered with the manufacturer so part coverage stays in effect. Financing is available through a third party, subject to credit approval.